Allied Telesis Support Portal

Resetting an AT-GS950/8POE to Factory Default

How do I set an AT-GS950/8POE to factory default?

To Return the Switch to Factory Defaults do the following:

****This process will cause the switch to reboot******

1. From the Tools folder, select Reboot.

2. For the Reboot Type field, use the pull-down menu to select one of the following:

Factory Default
Resets all switch parameters to the factory default settings, including the IP address, subnet mask, and gateway address.

Factory Default Except IP Address
Resets all switch parameters to the factory default settings, but retains the IP address, subnet mask, and gateway settings. If the DHCP client is enabled, it remains enabled after this reset.

3. For the Reboot Status field, use the pull-down menu to select Start to begin the reboot.

4. Click Apply.

The switch is rebooted. You must wait for the switch to complete the reboot process before reestablishing your management session.

In addition if you cannot access the Web Management, there is a small button on the front left panel that can be pushed for several seconds to restore the factory defaults
Previous MonthNext Month
SunMonTueWedThuFriSat