Allied Telesis Support Portal

Configuring the Active Boot Image on AT-8000S Series Switch

How do I set the active boot image on an AT-8000S series switch?

1. Do a "show bootvar" to find out which image is the active image and which is the inactive image.

2. Do a "boot system image-1" to make image-1 the startup or do a "boot system image-2" to make image-2 the startup.

3. After doing this, you will need to reboot the switch. You can use the command "reload" to reboot the switch.
Previous MonthNext Month
SunMonTueWedThuFriSat